CDI Box Instruction


Our CDI may use a different wire color code then your original. 
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.


Voltage Regulator Rectifier


Before installing your new regulator/rectifier 


1. Check the AC output of the regulator.

2. Replace any burned or corroded connectors on the regulator/rectifier.

3. Check and repair any melted wiring.

4. Use hi-temp dielectric grease on all connectors.


The two green wires are NEGATIVE, and the two red wires are POSITIVE. All depending on your application, if you just need one, splice together. The three yellow wires are for the phase three of our stator. No order is required for the wiring. Universal black wire is not required.  



CDI Box
Height: 75 mm
Width : 50 mm
Thickness: 22 mm

Number of wire : 5
Number of plug : 2

Voltage Regulator Rectifier
Seven wires
Bracket center to center 78 mm
Thickness 22 mm
Height 80 mm