There are no particular installation instructions for this stator.


Please refer to our generic stator installation instructions.


Before attempting to start your YAMAHA YFZ350 BANSHEE

1. This stator is designed as a direct plug-in replacement and should be used as such. 

2. Our stator may use different wire color code then your original.

3. All of the wires are installed in the correct order; please do not change any of the wiring configuration.

4. When bolting in, always use locking compound. 

5. Adjusting the air gap is necessary, to rotate the flywheel so the raised nod is lined up with the pick up/pulsar coil and adjust as close as possible but no less than 0.010".



STATOR REGULATOR RECTIFIER KIT

RM01049-Stator

Seven wires

Seven terminals

ALTERNATOR Yellow between each Yellow 0.6 ohms ±20%

ALTERNATOR Yellow to Ground  O.L. ON DISPLAY

PICKUP 1 Blue to Green 350 ohms ±20%

POSITION SENSOR Black to White 0.2 ohms ±20%

 

RM30204-Regulator

Five wires

Bracket center to center 60 mm

Thickness 25 mm

Height 48 mm