There are no particular installation instructions for this stator.


Please refer to our generic stator installation instructions.


Before attempting to start your YAMAHA YFZ350 BANSHEE

1. This stator is designed as a direct plug-in replacement and should be used as such. 

2. Our stator may use different wire color code then your original.

3. All of the wires are installed in the correct order; please do not change any of the wiring configuration.

4. When bolting in, always use locking compound. 

5. Adjusting the air gap is necessary, to rotate the flywheel so the raised nod is lined up with the pick up/pulsar coil and adjust as close as possible but no less than 0.010".

6. Set adjustable timing plate at zero for stock timing. 


CDI Box HP


Out CDI may use different wire color code than your original.

All of the wires are installed in the correct order; please do not change any of the wiring configuration.

This CDI is designed as a direct plus-in replacement and should be used as such.


Improved Flywheel


Adjusting the air gap is necessary, to rotate the flywheel so the raised nod is lined up with the pick up/pulsar coil and adjust as close as possible but no less than 0.010".






Banshee Generator Stator + CDI Box HP+Flywheel+External Ignition Coil

Generator Stator

Six wires
Six terminals
ALTERNATOR Yellow to Black 0.4 ohms ±20%
PICKUP 1 White/Green to White/Red 115 ohms ±20%
SOURCE 1 Green to Red 12 ohms ±20%

Interior Diameter: 42mm
Exterior Diamter: 103mm
Thickness: 28mm

CDI Box HP

The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.

External Ignition Coil

Bracket center to Bracket: 90mm

Improved Flywheel

Diameter of fly wheel- 130mm