There are no particular installation instructions for this stator.
Please refer to our generic stator installation instructions.
Remove the yellow wire from the external ignition coil, if not applicable to your model.
Our CDI may use different color code then you're original.
All of the wire are installed in the correct order, please do not change any of the wiring configurations.
This CDI is designed as a direct plug-in replacement and should be used as such.
STATOR CDI BOX IGNITION COIL GASKET KIT
ALTERNATOR White between each White 0.9 ohms ±20%
ALTERNATOR White to Ground O.L. ON DISPLAY
PICKUP Red to White 500 ohms ±20%
SOURCE Green to Black 300 ohms ±20%
Interior Diameter: 54mm
Exterior Diamter: 115mm
Bracket center to center: 85mm
Width: 25 mm
Length: 90 mm
The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.
--External Ignition Coil
Bracket to bracket center 55 mm