1. Solder RED wire from RM01293 stator to original BLACK/RED.


2. Solder WHITE wire from RM01293 stator to original WHITE/RED.


3. The two yellow wires for the RM01293 stator are provided for late model RM's that require a power valve supply. If your bike does not have these two wires you have two options.


A) Simply cut the wires and insulate them so they cannot short out.

B) Use it for a low wattage light. To do this you must route the two yellow wires through the stator harness.


Note: When bolting stator in always use locking compound.



Four wires

Four terminals

SOURCE 1 Red to White 28 ohms ±20%

SOURCE 2 Yellow to Yellow 0.4 ohms ±20%