KAWASAKI 1992-97  KX125,  1992-97   KX 250                                


1. Take the ignition cover off.

2.Take note of the wire colors of the original stator wires and disconnect them from the wiring loom.

3. Remove the flywheel using a proper puller tool.

4. Remove the base plate with the original stator.

5. Remove the screws that secure the ignition coils and take the coils off.

6. Cut the original wires close to the original coils. Take a good look at how the wires are connected to the coil.


7. CONNECTIONS: LARGE coil connects to the BLACK/RED and the RED wire. SMALL coils connects over to the large coils RED wire and the other side to the WHITE wire. Connect the wires on the same side of the coils as the original setup.


8. Mount the coils onto the base plate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY!

9. Refit the stator base plate. Ensure the wires CANNOT TOUCH THE FLYWHEEL! (especially on the inside of the flywheel)

10.Connect the wires to the wiring loom on the bike.

11. Fit the ignition cover.






YAMAHA YZ125 1992


1. Take the ignition cover off.

2. Take note of the wire colors of the original stator wires and disconnect them from the wiring loom.

3. Remove the flywheel using a proper puller tool.

4.Remove the base plate with the original stator.

5. Remove the screws that secure the ignition coils off.

6. Cut the original wires close to the original coils. Take a good look at how the wires are connected to the coil.


7. CONNECTIONS: LARGE coil connects to the BROWN wire, connect the other side up to the RED wire. SMALL coil connects to the BLACK wire (=ground) connect the other side up to the WHITE wire.


8. Connect the old wires up to the new coils. Put the wires in exactly the same as on the original. 

9. Make sure you have good connections here.

10.Mount the coils onto the base plate, fit the screws using locking compound on the threads and TIGHTEN THE SCREWS SECURELY!

11. Refit the stator base plate. Ensure the wires CANNOT TOUCH THE FLYWHEEL! (especially on the inside of the flywheel)

12.Refit the flywheel. Tighten the bolt to specified torque.

13. Connect the wires to the wiring loom on the bike. Refit the ignition cover.




STATOR IGNITION SOURCE COIL

BIG COIL Between each leg  323 ohms ±20%

SMALL COIL Between each leg 20 ohms ±20%