Please consult the generic stator installation instructions before installing your new stator.


RM01023 can be configured two different ways : 


Two 100 watts output

Used especially for direct stock OEM replacement when no additional output is required.

This configuration can also be used for most dual sport kits.


  1. Brown, Black/Red and two wire connector plugs back into stock wiring harness
  2. Plug back Green and White wires with male bullets into bike's wiring harness. 100 Watts available.
  3. Green & White wires with double female plugs is additional 100 Watts output. If additional output is to be used, a regulator is required. See diagram 2.


One 200 watts output

Usually used for additional lighting when there is no battery

Base configuration


  1. Brown, Black/Red and two wire connector plugs back into stock wiring harness
  2. Plug back Green and White wires with male bullets into bike's wiring harness. 100 Watts available.
  3. Green and White wires with double female plugs is additional 100 watts output. A regulator is required If additional output is to be used.

Configuration with light

  1. Brown, Black/Red and two wire connector plugs back into stock wiring harness
  2. Plug back Green and White wires with male bullets into bike's wiring harness. 100 Watts available.
  3. If stock AC regulator is to be used in place of the regulator shown, wire OEM freen in place of brown & OEM white/yellow in place of yellow

Configuration with battery

  1. Brown, Black/Red and two wire connector plugs back into stock wiring harness
  2. Plug back Green and White wires with male bullets into bike's wiring harness. 100 Watts available.



HO STATOR 200 WATTS

Eight wires

Eight plugs

ALTERNATOR Green to White 0.6 ohms ±20%

PICKUP Green to Blue 230 ohms ±20%

SOURCE Black/Red to Brown 100 ohms ±20%

 

Interior Diameter: 54mm

Exterior Diameter: 115mm

Thickness:  27mm